Blu-Ray Support

ddoering · **Joined:** Fri Mar 16, 2007 10:06 pm **Posts:** 1

I am using a Sony BWU-100A Blu-Ray recorder. Grab and Burn recognizes it, and acknowledges that there's a blank BD-R in the drive, but only says that it is an "Unknown" disc.

If I continue with the Disc Burning Wizard, I get an error message that says that the disc is an "Unknown" type and do I want to proceed at my own risk.

If I do, and select my files, then click Next, an error message appears that says "Source is too long to feet the destination" and the software won't continue. (I made sure, and went as low as 12GB on the 25GB disc, but all give the same error.)

There don't appear to be any specific instructions in the Help on working with Blu-Ray discs or Unknown discs.

Any suggestions??

Dave Doering
TechVoice

anton (staff) · **Posted:** Sat Mar 17, 2007 1:32 pm

There are some known issues with this burner. We'll either fix it soon or completely replace Grab&Burn with StarBurn application.

ddoering wrote:

I am using a Sony BWU-100A Blu-Ray recorder. Grab and Burn recognizes it, and acknowledges that there's a blank BD-R in the drive, but only says that it is an "Unknown" disc.

If I continue with the Disc Burning Wizard, I get an error message that says that the disc is an "Unknown" type and do I want to proceed at my own risk.

If I do, and select my files, then click Next, an error message appears that says "Source is too long to feet the destination" and the software won't continue. (I made sure, and went as low as 12GB on the 25GB disc, but all give the same error.)

There don't appear to be any specific instructions in the Help on working with Blu-Ray discs or Unknown discs.

Any suggestions??

Dave Doering
TechVoice

#1 Burning Software

Blu-Ray Support

Who is online