#1 Burning Software

Any updated advice on this issue? I'm using two burning libraries in my application, both over COM, but only StarBurn causes very many of these error messages (I got a couple of hundred error reports). I'm registering the StarBurnX.dll on every setup and even attempt to do so at the startup of the application, if StarBurnX.dll cannot be loaded. The DLL can be loaded fine in such cases though. Would re-registering the DLL help? Actually, even if it did, the application would need admin permissions first.

You need remove and de-register existing DLL first. If multiple apps share the same DLL you'll have to use manifests.

So...on each setup I am supposed to de-register and then register the DLL?
What about manifests? Can you elaborate a little on that one?

No you don't need. Stick with the manifest thing (Dima will put some more light on it now).

Hello,

1) Use the IStarBurnX2 interface;

IStarBurnX2 starBurn = new StarBurnXClass();

2) Refresh the reference of StarBurnX component for your application;

3) Select the right target platform - x86 or x64 .. do not use the "independent" target platform;

4) Installation of StarBurnX include two minifest files - "StarBurnX12x64.dll.manifest" and "StarBurnX12.dll.manifest";

Note: the "free-registration" method should work with StarBurnX ... at least you are first who reported about this problem

Regards,

Dmitry

Hello,

Which Windows version do you use?:)

Regards,

Dmitry

Windows 7 (x64).

Ok, we will test this issue!

Regards,

Dmitry

Any news yet?

(I hate to annoy, but this issue is rather important to me.)

Hello,


Not yet, sorry

We will investigate it ASAP!!!

Regards,

Dmitry

Hello,

Ok, Thanx!! We will investigate this solution ASAP!!

Regards,

Dmitry